First Images with the Orion StarShoot DSI II – 7/03-04/2010
Finally got the chance to try out the new to me Orion StarShoot Color Deep Sky Imager (DSI) II I picked up on Astromart Classifieds a while back. Saturday and Sunday night were both nice. Clear skies and cooler than it has been. A few clouds rolled by later on Sunday night, but still a great night.
For all images I used PHD for guiding, MaxIm DL Essentials for imaging with the DSI, and Deep Sky Stacker to stack the exposures.
On Saturday (7/3/2010) I set up to image through the Celestron 6″ SCT with a f/6.3 focal reducer while using the Astro-Tech 66ED to guide.
Early in the evening I used Venus to get the two scopes aligned and to test focus of the imaging camera and the guide camera.
After doing the two star alignment on the mount I used the polar align routine on the hand controller to make sure I had my alignment down. Not bad, had to make a few minor adjustments.
I then redid the two star alignment using Spica and Arcturus for my alignment stars and Antares, Deneb, Albireo, and Vega for my calibration stars.
The first target for the camera was the globular cluster Messier 4 (M4). It took some work to get the globular in focus, and I think I am still a little off – something I am going to have to work on a bit. The first set of images were over exposed, I changed the screen stretch to MaxVal and that fixed that. I ended up with 10 60 second exposures.
I then moved on the Messier (M80). I forced calibration in PHD after moving to each new object. I ended up with 10 decent 60 seconds exposures and stacked them to get the image below.
Messier 22 (M22) is a great globular cluster to observe visually and I think if I can increase my exposure times a bit it will be a great one to photograph as well. The image below is 12 60 seconds exposures stacked.
This one was not on my plan, but Mary Shannon had seen M57 at the SkyWatch on Friday night and wanted me to try to get a photo of it. Messier 57 (M57), also known as the Ring Nebula, turned out to be my favorite image of the night. My guiding was off, I think I have an issue with balance, but the 7 30 second exposures look pretty good stacked.
Sunday (7/4/2010) night was a bit warmer with a light breeze. I decided to image through the Astro-Tech 66ED with an Orion Skylight filter and use the Celestron 6″ SCT to guide. I just wanted to get a feel for the difference in imaging between the two scopes.
I went through the same alignment process as the night before. Again using Spica and Arcturus to align and Antares, Deneb, Albireo, and Vega for calibration. I did not do the polar alignment routine, the GOTOs to the calibration stars were pretty much dead on so I figured it was probably still in good alignment.
The first target was Messier 10 (M10). Here are 16 60 second exposures stacked.
Then on to one of my new favorites to observe Messier 20 (M20) the Trifid Nebula. It was hard to find in the camera at first, the nebula does not show up until you increase the exposures to 10 seconds or more, because of this it took some work to get it close to center. I ended up with 21 60 second exposures and I think it turned out great.
I still had a problem with guiding. It wanted to drift south and the guider could not keep up. Not sure if it is a polar alignment problem or a problem with balance. Going to have to look at this a bit more. The PHD test moves the mount fine E & W RA and N & S DEC so I think the guide pulses are being sent. Going to have to research this a bit more to figure it out.
Both the 6″ SCT and the AT66ED produced decent images with DSI. With the wider field it was easier to locate and center images in the AT66ED. I still need to work on fine tuning my focus but I am pretty happy with how the images turned out. I learned a lot about the camera, the scopes, and the process plus I really enjoyed taking them (that’s what really matters).
